本文目录一览：
跪求能在win7 64位系统上运行的proe5.0软件的下载与安装讲解！
.boot up your pc with windows
.start pro/e setup
.open ptc_licfile.dat with your fav txt-editor
.replace every occurance of 00-00-00-00-00-00 with the one shown in the bottom left corner of the Pro/e setup
(its your mac-id, format: xx-xx-xx-xx-xx)
.install pro/e - pro/m - pro/ds, i dont care which one or in which order
.on license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
.blalala install
next for pro/engineer:
(if u didnt install the complete package, u get "missing file" errors, accept or bleed)
.run ptc.pro engineer.wildfire.4.0-patch.exe, point to installdir\i486_nt\obj folder
.edit pro/e installdir\bin\proev.bat
change "%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr%" in
"%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr% PTC_KEY=0"
(add PTC_KEY=0)
pro/mechanica:
.run ptc.pro mechanica.wildfire.4.0-patch.exe
.point to pro/m installdir\i486_nt\bin
pro/m installdir\i486_nt\obj
pro/m installdir\i486_nt\ptc
(in this order, after every "missing file" error)
pro/distributed services:
.run ptc.distributed.services.4.0-patch.exe and point to pro/ds installdir\i486_nt\obj
先将你的网卡好替换破解文件里面的00-00...-00,安装时选上这个作为KEY；完成后
安装后将对应的破解文件放到对应的文件夹里，双击运行，然后点确定，有些时候会弹出来“missing file” 是有些模块没有安装，所以不用管，取消就OK乐，破解完就OKl额！！！
